The clutch release bearing is an important part of the car. If it is not well maintained and malfunctions, it will not only cause economic losses, but also it is quite troublesome to disassemble and assemble once, and it takes a lot of man-hours. Therefore, to find out the cause of the clutch release bearing failure, and to maintain and maintain it reasonably during use, is of great significance to prolong the life of the release bearing, improve labor productivity, and obtain better economic benefits.

The clutch release bearing is installed between the clutch and the transmission. The release bearing seat is loosely sleeved on the tubular extension of the first shaft bearing cover of the transmission. The shoulder of the release bearing is always against the release fork through the return spring and retracts to the final position. , Keep a gap of about 3~4mm with the end of the separation lever (separation finger).

Since the clutch pressure plate, the release lever and the engine crankshaft operate synchronously, and the release fork can only move axially along the output shaft of the clutch, it is obviously impossible to directly use the release fork to dial the release lever. The release bearing can make the release lever rotate side by side. The output shaft of the clutch moves axially, which ensures that the clutch can engage smoothly, disengage softly, reduce wear, and extend the service life of the clutch and the entire drive train.

Use note:

1) In accordance with the operating regulations, avoid the clutch half-engaged and half-disengaged, and reduce the number of times the clutch is used.

2) Pay attention to maintenance. Use the steaming method to soak the butter so that it has sufficient lubricant during regular or annual inspection and maintenance.

3) Pay attention to leveling the clutch release lever to ensure that the elastic force of the return spring meets the requirements.

4) Adjust the free stroke to meet the requirements (30-40mm) to prevent the free stroke from being too large or too small.

5) Minimize the number of joining and separation, and reduce the impact load.

6) Step on lightly and easily, so that it can be joined and separated smoothly.

Taizhou Benwo Auto Parts Co., Ltd. is a China Release Bearing Manufacturer with a variety of auto parts products. Welcome to visit our official website.