Gas Boiler price Features
1) The large font shows the water temperature, which is convenient for mastering the operation status of the boiler and system. The water temperature can be set freely from 10 °C to 90 °C. The boiler can automatically heat the system or provide users with hot water for living and bathing.
2) The control system controls the start and stop of the circulating pump according to the temperature of the furnace water. When the furnace water reaches the set upper limit water temperature, the hot water circulation pump starts, and when the water temperature is lower than the set lower limit water temperature, the hot water circulation pump stops.
3) The horizontal gas bath boiler is a three-pass full wet back structure, which adopts the design of large furnace and thick smoke pipe to increase the heat absorption of the furnace and effectively save energy and reduce consumption.
The use of threaded pipe and corrugated furnace greatly enhances the heat transfer effect and greatly saves fuel consumption.
4) The whole machine is equipped with overheat protection at the same time (when the water temperature in the furnace is too high, the burner automatically stops working and buzzer alarm), secondary overheat protection (when the boiler shell temperature exceeds 105 °C, the secondary circuit is automatically cut off), anti-dry Water shortage protection (when the boiler water is lower than the extremely low water level, the boiler stops working and emits a buzzer alarm), and the boiler leakage protection (the control system will automatically cut off the power after detecting the electrical leakage or short circuit).
5) The boiler is designed according to the normal pressure structure, and the boiler is in a non-pressure state without any safety hazard.
6) It adopts advanced centrifugal glass wool multi-layer insulation, and the famous white color steel plate is used for outer packaging, which has less heat loss and beautiful rust resistance.
Precautions
1) After a long period of operation, the boiler will inevitably have scale and rust problems.
The main reason for the formation of scale in boilers is that the water has a hardness component. After continuous evaporation and concentration of high temperature and high pressure, a series of physical and chemical reactions take place in the furnace, and finally a hard and dense scale is formed on the heated surface, resulting in replacement. Reduced thermal effect.
Moreover, due to the corrosion factor under the scale, the heat absorption of the boiler water-cooled fireplace will be reduced, and the boiler furnace outlet temperature will increase, which will increase the boiler loss.
At the same time, the scale effect in the water wall reduces the heat transfer effect, which may cause the water wall wall temperature to increase, causing the water wall to burst, which affects the safe operation of the boiler.
2) Scale is the “one of the best” of the boiler, which is the main cause of boiler accidents.
Its hazard is mainly manifested as: wasting a lot of fuel.
Because the thermal conductivity of scale is only a few tenths of that of steel, when the heating surface is fouled, the heat transfer will be blocked. In order to maintain a certain output of the boiler, it is necessary to increase the temperature of the fire side, so that the radiation and smoke are radiated outward. Cause heat loss.
It is now possible to clean the gas boiler with a highly efficient and environmentally friendly non-corrosive cleaning agent, so that the equipment tube exposes the primary color of the metal, reducing the influence of fouling and biological algae sludge.
At the same time, it has the effect of stripping iron oxide and iron oxide, which can prolong the service life of gas boilers, reduce energy consumption and increase productivity.
Gas Boiler price
website:http://www.jn-boiler.com/fuel-gas-boiler/gas-boiler/
English
Arabic
Français
Español
Português
Deutsch
Dutch
Italiano
Russian
Romaian