How long can the 4g car gps tracker installed on the car last? |...

How long can the 4g car gps tracker installed on the car last?

Veröffentlicht 2021-12-02 09:56:42

How long can the 4g car gps tracker installed on the car last? 4g car gps tracker has become a must-have product for car owners. No matter where you buy it, buyers want to be able to use it for a longer period of time. However, for electronic products, the service life is related to the environment and product quality itself. How long can the service life of a normal 4g car gps tracker be? I believe many friends will be very curious.

First of all, for the 4g car gps tracker, the biggest impact on the life is actually the health of the internal PCB circuit board. When we install the GPS inside the body, the vehicle will usually be parked in the open air, if it is in the high temperature environment in the summer afternoon ( Sometimes the temperature inside the car can reach sixty to seventy degrees). At this time, for the PCB circuit board, it is easy to cause the risk of accelerated aging of electronic components, and at the same time make the solder joints more likely to crack and loosen.

Secondly, if the 4g car gps tracker is purchased to support the power failure alarm function, then a spare small-capacity polymer lithium battery pack may be installed inside the device. When the 4g car gps tracker is used for two to three years, the spare battery will be It will gradually age, not only the charging time is not as fast as the original speed, but the power consumption is also very fast. At the same time, the manufacturer's warranty for the backup battery of the GPS locator is within one year, which is also the reason for affecting the service life.

There is another situation that occurs more frequently, which is also the cause of greater harm to the GPS car locator: moisture and water seepage. In a humid environment, the electronic components on the PCB circuit board will be damaged due to tiny water droplets. This process is slow and usually takes 1-3 months. Water seepage can immediately cause a short circuit of the PCB circuit. As a result, the entire equipment can no longer be used, commonly known as scrap.