In Waste Oil to Base Oil plants, solvent extraction is a critical but often under-optimized step. It separates polar contaminants like oxidized molecules, sludge-forming agents, and degraded additives. However, incorrect solvent ratios or contact times can reduce base oil yield and purity. This blog offers practical guidance on fine-tuning solvent extraction parameters for improved efficiency.
Understanding Solvent Extraction
Solvent extraction targets asphaltenes, resins, and oxidized additives that reduce the thermal stability of recycled base oil. Common solvents include MEK (methyl ethyl ketone), propane, or furfural. These solvents selectively dissolve base oil while rejecting heavier, less soluble contaminants.
Key Parameters to Optimize
Solvent-to-Oil Ratio (SOR):
A common range is 1:1 to 3:1.
Higher ratios improve contaminant separation but require more solvent recovery infrastructure.
Sweet spot: ~2.2:1 for SN500-grade recovery.
Extraction Temperature:
Low temps can cause solvent crystallization; high temps may degrade oil.
Ideal range: 50–60°C for MEK-based systems.
Residence Time in Mixer-Settler Units:
Longer residence time improves separation but increases throughput time.
Optimize between 20–35 minutes depending on the solvent used.
Real-World Case Study
A plant in Eastern Europe tested varying SOR levels and found that increasing the ratio from 1.8:1 to 2.3:1 improved Group I base oil clarity by 17% while maintaining a cost increase of only 6% in solvent recycling. The plant later incorporated solvent regeneration to offset operating expenses.
Common Pitfalls
Solvent Degradation: Reuse without proper regeneration can introduce artifacts into the base oil.
Incomplete Mixing: Results in inefficient phase separation and solvent loss.
Over-Extraction: Removes valuable lighter fractions if not carefully managed.
Conclusion
Solvent extraction is not just about choosing the right solvent—it's about controlling the parameters that govern performance. A data-driven approach to SOR, temperature, and time will yield significant improvements in base oil quality and profitability.
English
Arabic
Français
Español
Português
Deutsch
Türkçe
Italiano
Russian
Romaian