Stainless Steel Self Priming Chugger PUMP uses polyvinylidene fluoride (PVDF) to enhance polypropylene (RPP) once injection molding. High mechanical strength, strong corrosion resistance, self-suction pump structure has a scientificity, and a liquid-absorbent chamber, a liquid storage chamber, a liquid return valve, a gas-liquid separation chamber, and a backflow hole. It is only necessary to fill the lead in the initial boot, there will be no need to repeat the infusion color, when the medium is suggested, the liquid can be intermittent, and the liquid can continue to be sucked within 15 minutes, and the mechanical seal does not require additional cooling water cooling. Easy to operate, safe without leakage, is a product of the substituted liquid pump.

　　The user is very important in the sequence of STAINLESS Steel Self Priming Chugger Pump. The order is not the function of the overall function, let's take a clutter.

　　Stainless Steel Self Priming Chugger Pump Disassembly Sequence:

　　1. Remove the motor or take out the coupling.

　　2. Remove the bearing assembly, check the radial gap of the impeller and the foreklings, and check that the impeller nut is loose.

　　3. Remove the impeller nut, pull the impeller, check the radial gap of the impeller and the rear seal ring.

　　4. Tixing the mechanical seal tight screw, pull out the mechanical seal of the hi-ring portion, check the bonding of the moving, the static ring end surface, and check the sealing of the O-shaped seal.

　　5. Spin out the tight screw of the coupling, pull out the coupling.

　　6. Remove the bearing end cover, remove the pump shaft and bearing.

　　7. Stainless Steel Self priming chugger Pump is installed in the opposite order.

　　Stainless Steel Self Priming Chugger Pump takes special attention to several items:

　　1. The pump has arrived in the use site, and it is necessary to check whether the whole machine parts are intact before installation. The fasteners should be fastened, check the concentricity of the pump shaft and motor shaft, if there is shift, should be corrected.

　　2. Try to minimize the hydraulic loss of the suction line, should not be less than 90 ° elbow, the elbow of 90 ° on the imported pipe should not exceed 2, the pump import should be set, prevent large block impurities into the pump Let the pump can be running normally and reduce the imported pipeline path as possible (this will reduce the imported pipe air, thereby reducing self-suction time, increasing working efficiency).

　　3. The connection bolts of the water pipe must be tightened, and the seal must be strict, can not leak, try to use a soft flange gasket (such as fluororne rubber), otherwise it will seriously affect the self-suction performance of the pump.

　　Stainless Steel Self priming chugger pump https://www.luolintec.com/stainless-steel-self-priming-centrifugal-pump.html