atient assessment, need for folic acid supplementation, and toxicity monitoring. • Areas of disagreement relate to methotrexate starting and maximal dose, titration, and frequency of assessments. Existing recommendations do not uniformly address all aspects related to the use of MTX and disagree in relevant aspects of MTX use. Adaptations to these recommendations are needed to facilitate their implementation in LDCs. Key Points • This paper summarizes current recommendations on the use of methotrexate for the treatment of rheumatoid arthritis. • Areas of agreement between recommendations include the following pre-methotrexate patient assessment, need for folic acid supplementation, and toxicity monitoring. • Areas of disagreement relate to methotrexate starting and maximal dose, titration, and frequency of assessments. The evidence shows that previous infection with enteric pathogens is a requirement to develop pSpA. Based on our previous results, variances on regulation of SIgA might influence SpA activity; thus, the aim of this study was to correlate the levels of SIgA, IgA against some enteric bacteria, and IL-17, IL-21, and IL-6 with clinical features in a group of SpA patients. Twenty-six pSpA, 20 nr-axSpA, 60 healthy volunteers (HV), and 34 patients with inflammatory bowel diseases (IBD) were included. All subjects were assessed to measure SIgA, total and specific IgA for enteric bacteria, and IL-17, IL-21, and IL-6 levels and clinical variables. For SpA patients, the diagnosis was verified 5 years after first evaluation to assess the risk of developing r-axSpA. SIgA levels were significantly higher in SpA patients than in HV and IBD (p < 0.0001 and p = 0.047, respectively). However, no differences for SIgA neither total IgA were found among the SpAsubtypes (p = 0.624). Only IL-6 was higher in SpA than HV (p ease activity but not in this progression. Key Point • The levels of SIgA, IgA against some enteric bacteria, and IL-17, IL-21, and IL-6 are correlated with clinical features in a group of SpA patients. To investigate the characteristics, evolution, and visual outcome of non-infectious uveitis. Records of 201 patients with non-infectious uveitis (136 (67.7%) males and 84 (41.8%) juvenile-onset (≤ 16years)) were retrospectively reviewed. Data were analyzed through Kruskal-Wallis and Mann-Whitney, chi-square (χ ) tests, and logistic regression. The median disease and follow-up durations were 36 (interquartile range (IQR) 24-70) and 24 (IQR 10-36)months, respectively. Fifty-eight (28.9%) patients had persistently idiopathic uveitis, and 143 (71.1%) were associated with rheumatic diseases, of whom uveitis heralded, coincided with, and succeeded the rheumatic manifestation(s) in 62/143 (43.4%), 37/143 (25.9%), and 44/143 (30.7%) patients, respectively. Established rheumatic diseases were Behçet's disease (103/201 (51.2%)), juvenile idiopathic arthritis (13/201 (6.5%)), sarcoidosis (8/201 (4%)), seronegative spondyloarthropathy (7/201 (3.5%)), and Vogt-Koyanagi-Harada (7/201 (3.5%)), and other diagnoses wery presented only with uveitis, more commonly in adult and male patients. • Panuveitis was more frequent among patients with an established rheumatic disease, whereas granulomatous uveitis was uncommon. • Longer disease duration and presence of panuveitis were independently associated with visual loss. Behçet's disease (51.2%) and idiopathic uveitis (28.9%) were the most prevalent causes of non-infectious uveitis in our study. Visual loss (22.3%) was associated with a longer disease duration, lower education level, and prevalent panuveitis. Key Points • Most common causes of uveitis referred to rheumatologists were Behçet's disease and idiopathic uveitis. https://www.selleckchem.com/products/citarinostat-acy-241.html • Several rheumatic diseases initially presented only with uveitis, more commonly in adult and male patients. • Panuveitis was more frequent among patients with an established rheumatic disease, whereas granulomatous uveitis was uncommon. • Longer disease duration and presence of panuveitis were independently associated with visual loss. ABP 798 is a proposed biosimilar to the originator biologic rituximab, an anti-CD20 monoclonal antibody. This comparative clinical study evaluated the pharmacokinetics (PK), safety, and efficacy of ABP 798 versus rituximab reference product (RP) in patients with moderate-to-severe rheumatoid arthritis (RA). Adults with moderate-to-severe RA with an inadequate response or intolerance to other disease-modifying anti-rheumatic drugs including 1 or more tumor necrosis factor inhibitor therapies (n = 311) received ABP 798, US-sourced rituximab RP (rituximab US), or EU-sourced rituximab RP (rituximab EU) (1000mg, 2weeks apart). At week 24, ABP 798- or rituximab EU-treated subjects received a second dose of the same treatment, while rituximab US-treated subjects transitioned to receive ABP 798. The key efficacy endpoint was DAS28-CRP change from baseline at week 24. Other efficacy endpoints included DAS28-CRP at other time points; ACR20, ACR50, and ACR70 criteria; and hybrid ACR. The rituximab RP groups were poo equivalence in terms of efficacy, safety, and immunogenicity was established between ABP 798 and rituximab RP in this comparative clinical trial in patients with moderate-to-severe RA. Key Points • ABP 798 provided similar efficacy as rituximab reference product (RP) in patients with moderate-severe rheumatoid arthritis. • The safety and immunogenicity profiles for ABP 798 were similar to those for the rituximab RP. • The single transition from rituximab RP to ABP 798 did not show differences in efficacy, safety, or immunogenicity. Computer navigation and patient-specific instrumentation for total ankle arthroplasty have still to demonstrate their theoretical ability to improve implant positioning and functional outcomes. The purpose of this paper is to present a new and complete total ankle arthroplasty customization process for severe posttraumatic ankle joint arthritis, consisting of patient-specific 3D-printed implant and instrumentation, starting from a ligament-compatible design. The new customization process was proposed in a 57-year-old male patient and involved image analysis, joint modeling, prosthesis design, patient-specific implant and instrumentation development, relevant prototyping, manufacturing, and implantation. Images obtained from a CT scan were processed for a 3D model of the ankle, and the BOX ankle prosthesis (MatOrtho, UK) geometries were customized to best fit the model. Virtual insilico, i.e., at the computer, implantation was performed to optimize positioning of these components. Corresponding patient-specific cutting guides for bone preparation were designed.