In the absence of inconsistencies, all metrics converged to the same regularization weights, whereas structural similarity index metric was more insensitive to such inconsistencies. CONCLUSION There was a mismatch between the provided data and the ground truths due to the presence of unaccounted anisotropic susceptibility contributions and noise. Given the lack of reliable ground truths when using in vivo acquisitions, simulations are suggested for future QSM Challenges. © 2020 International Society for Magnetic Resonance in Medicine.AIM To evaluate the systemic conditions, tooth loss, oral health, body image perceptions, and quality of life of women with obesity and women who underwent bypass surgery. METHODS AND RESULTS Sixty women were classified into the gastric bypass (G1, n = 30) and obesity (G2, n = 30) groups, and their systemic condition, oral health perception, oral hygiene, tooth loss, body image perception (Stunkard scale), and quality of life (WHOQOL-bref) were evaluated. The t-test, Mann-Whitney, chi-square, and multiple linear regression were used for statistical analysis (P  less then  .05). G2 presented higher prevalence of hypertension (P = .020) and G1 higher prevalence of anemia (P = .040). G2 demonstrated less favorable perceptions of oral health, primarily associated with chewing (P = .0007) and speech (P = .005), and a lower frequency of dental floss usage (P = .047); however, there were no intergroup differences regarding the prevalence of missing teeth (P = .180). G1 demonstrated greater satisfaction with regard to their body image (P  less then  .0001), contrary to those in G2, who negatively perceived the same (P = .001), particularly considering the physical, psychological, and environmental parameters (P  less then  .05). CONCLUSION High body mass index (BMI) indicated a higher prevalence of hypertension and a negative impact on oral health perception and quality of life. However, bariatric surgery was associated with a positive body image perception and quality-of-life parameters. © 2020 Special Care Dentistry Association and Wiley Periodicals, Inc.BACKGROUND Transgenic animals are widely used for research and for most of them, genotyping is unavoidable. Published protocols may be powerful but may also present disadvantages such as their cost or the requirement of additional steps/equipment. Moreover, if more than one strain must be genotyped, several protocols may need to be developed. METHODS we adapted the existing amplification-resistant mutation protocol to develop the 1-h universal genotyping protocol (1-HUG), which allows the robust genotyping of genetically modified mice in 1 h from sample isolation to polymerase chain reaction gel running. RESULTS This protocol allows the genotyping of different mouse models including mdx mouse, and FLExDUX4 and HSA-MerCreMer alone or in combination. It can be applied to different types of genomic modifications and to sexing. CONCLUSIONS The 1-HUG protocol can be used routinely in any laboratory using mouse models for neuromuscular diseases. © 2020 Wiley Periodicals, Inc.Aseptic loosening is the most common indication for revision of cementless acetabular cups and often depends on the primary stability achieved following surgery. Cup designs must be capable of achieving primary stability for a wide variety of individuals and surgical conditions to be successful. Typically, preclinical finite element (FE) testing of cups involves assessing the performance in a single patient and under a limited set of idealized conditions. The aim of this study was to assess the effect of patient and surgical parameters on the primary stability of an acetabular cup design in a set of subject-specific FE models. Interference fit was varied in a representative set of 12 patient-specific models of the implanted hemipelvis. Linear mixed models showed a significant association with micromotion for interference fit (P  less then  .0001), acetabular bone elastic modulus (P  less then  .001), native acetabular diameter (P  = .03), and the interference fit-elastic modulus interaction (P = .01). There were no significant associations between the polar gap and any of the parameters considered. The significant interference fit-elastic modulus interaction suggests that increasing the interference fit in patients with low bone quality leads to a greater reduction in micromotion than in patients with higher bone quality. However, the significant association between percentage bone yielding and interference fit (P  less then  .0001) suggests a higher periacetabular fracture risk at higher interference fits. This work supports the development of preclinical testing of cup designs for the broad range patients and surgical conditions a cup may face following surgery. © 2020 Orthopaedic Research Society. Published by Wiley Periodicals, Inc.OBJECTIVE To compare femoral stem subsidence and determine contributing factors in dogs undergoing total hip replacement (THR) with the traditional BFX, collared BFX, and BFX lateral bolt stems. STUDY DESIGN Retrospective radiographic study. SAMPLE POPULATION Ninety-three dogs with 101 THR including dogs undergoing THR with a BFX lateral bolt femoral stem (n = 40), BFX collared stem (n = 21), and traditional BFX stem (n = 40). METHODS Radiographs of traditional BFX (n = 40), collared BFX (n = 21), and BFX lateral bolt (n = 40) THR performed from 2015 to 2018 were reviewed. Subsidence, canal flare index (CFI), stem canal fill (CF), stem orientation, and complications confirmed on radiographs were recorded at postoperative and recheck radiographs. Analysis of variance tests were used to compare subsidence, CFI, stem orientation, and CF. A χ2 analysis was performed to compare complication rates between groups. https://www.selleckchem.com/products/mk-8353-sch900353.html RESULTS Subsidence was lower after placement of BFX lateral bolt stems (median, 0.24 mm; interquartile geons.INTRODUCTION Evaluation of nerve mechanical properties has the potential to improve assessment of nerve impairment. Shear wave velocity, as measured by using shear wave (SW) ultrasound elastography, is a promising indicator of nerve mechanical properties such as stiffness. However, elucidation of external factors that influence SW velocity, particularly nerve tension, is required for accurate interpretations. METHODS Median and ulnar nerve SW velocities were measured at proximal and distal locations with limb positions that indirectly altered nerve tension. RESULTS Shear wave velocity was greater at proximal and distal locations for limb positions that induced greater tension in the median (mean increase proximal 89.3%, distal 64%) and ulnar (mean increase proximal 91.1%, distal 37.4%) nerves. DISCUSSION Due to the influence of nerve tension when SW ultrasound elastography is used, careful consideration must be given to limb positioning. © 2020 Wiley Periodicals, Inc.