Low-density polyethylene (LDPE), as an excellent dielectric insulating material, is widely used in electrical equipment insulation, whereas its low thermal conductivity limits its further development and application. Hexagonal boron nitride (h-BN) filler was introduced into LDPE to tailor the properties of LDPE to make it more suitable for high-voltage direct current (HVDC) cable insulation application. We employed melt blending to prepare h-BN/LDPE thermally conductive composite insulation materials with different contents. https://www.selleckchem.com/products/GSK461364.html We focused on investigating the micromorphology and structure, thermal properties, and electrical properties of h-BN/LDPE composites, and explained the space charge characteristics. The scanning electron microscope (SEM) results indicate that the h-BN filler has good dispersibility in the LDPE at a low loading (less than 3 phr (3 g of micron h-BN particles filled in 100g of LDPE)), as well as no heterogeneous phase formation. The results of thermal conductivity analysis show that the introduction of h-BN filler can significantly improve the thermal conductivity of composites. The thermal conductivity of the composite samples with 10 phr h-BN particles is as high as 0.51 W/(m·K), which is 57% higher than that of pure LDPE. The electrical performance illustrates that h-BN filler doping can significantly inhibit space charge injection and reduce space charge accumulation in LDPE. The interface effect between h-BN and the substrate reduces the carrier mobility, thereby suppressing the injection of charges of the same polarity and increasing the direct-current (DC) breakdown strength. h-BN/LDPE composite doped with 3 phr h-BN particles has excellent space charge suppression effect and high DC breakdown strength, which is 14.3% higher than that of pure LDPE.In the present study, three red-colored (Dark Opal, Basilico Rosso, and Red Basil) and one green-colored landrace (Mitikas) of basil (Ocimum basilicum L.) were grown under four nitrogen regimes, namely Control (no fertilizer added), 200 ppm, 400 ppm, and 600 ppm of nitrogen (N). Fresh yield varied depending on N input following a quadratic function in all four genotypes, and green basil performed better compared to the red cultivars. A significant interaction of genotype × N input was recorded for most of the chemical parameters measured. Tocopherols contents of leaves were consistently higher in plants that received 200 ppm of N and lower in those receiving 600 ppm of N, especially in Dark Opal and Red Basil cultivars. Polyunsaturated fatty acids (PUFA) were the major category of fatty acids and Red Basil had the lowest ratio of omega-6/omega 3 (0.29) and thus the best fatty acid profile. Polyphenols content was the highest in Red Basil and Dark Opal (25 mg/g of extract on average) and the lowest in Mitikas and decreased with increasing N input. Similarly, antioxidant activity was the highest in Dark Opal and Red Basil fertigated with 200 ppm of N, whereas all the leaf extracts tested had good antibacterial and antifungal activity. In conclusion, basil chemical and bioactive profile was significantly influenced by both genotype and N input. Red-colored basil, although less productive, had the best chemical profile, and moderate levels of N input may provide the best compromise between yield, nutritional value, and bioactivity for the species.Type 2 diabetes poses a major public health challenge. Here, we conducted a cohort study with a large sample size to determine the association of baseline serum ferritin (SF), a marker of iron status, with incident type 2 diabetes in primary healthcare patients in Catalonia, a western Mediterranean region. A total of 206,115 patients aged 35-75 years without diabetes and with available baseline SF measurements were eligible. The variables analyzed included sociodemographic characteristics, anthropometry, lifestyle, morbidity and iron status (SF, serum iron and hemoglobin). Incident type 2 diabetes during follow-up (2006-2016) was ascertained using the International Classification of Diseases, 10th edition. Cox proportional-hazards models adjusted for multiple baseline confounders/mediators were used to estimate hazard ratios (HRs). Over a median follow-up of 8.4 years, 12,371 new cases of type 2 diabetes were diagnosed, representing an incidence rate of 7.5 cases/1000 persons/year. Since at baseline, the median SF concentration was higher in subjects who developed type 2 diabetes (107.0 µg/L vs. 60.3 µg/L; p less then 0.001), SF was considered an independent risk predictor for type 2 diabetes; the multivariable-adjusted HRs for incident type 2 diabetes across SF quartiles 1-4 were 1.00 (reference), 0.95 (95% CI = 0.85-1.06), 1.18 (95% CI = 1.65-1.31) and 1.51 (95% CI = 1.36-1.65), respectively. Our study suggested that higher baseline SF was significantly associated with an increased risk of new-onset type 2 diabetes in Catalan primary healthcare users, supporting the relevance of monitoring iron stores in order to improve the diagnosis and management of diabetes in clinical practice.Offshore waste disposal facilities are unique marine infrastructures that exist only in a few countries. Although the existing facilities in Japan and Singapore have been successfully operated in general, there have been no investigations on the probable hazards they pose on the environment. Considering this, conceivable hazards were identified for an offshore waste disposal facility that has recently been proposed in Korea. The causes and consequences of each of the identified hazards were analyzed to seek countermeasures for reducing the environmental impact in advance. Hazards of waste disposal facilities can be classified according to their design, construction, maintenance, operation, and site utilization. For these areas, except for site utilization, subsystem hazard analysis was performed. In the initial assessment, seven elements were found to be in the extreme risk zone, 30 were in the high-risk zone, and six were in the moderate-risk zone. After applying the alternative mitigation methods, the final risk assessment resulted in 27 moderate-risk and 16 low-risk elements. Therefore, it was confirmed that the potential risks of the proposed offshore waste disposal facility were within acceptable ranges.