Femtosecond-laser ionization mass spectrometry (fs-LIMS) is demonstrated to be a powerful analytical method providing access to the qualitative distinction of structural isomers of ortho-, meta-, and para-fluorotoluene. The key point of the approach presented is a systematic variation of the spectral phase of the fs-laser pulses, which characteristically affects the fragmentation pattern observed in the mass spectra. Variation of the linear chirp parameter is also helpful for rationalizing the fragmentation mechanism. Ultimately two ternary mixtures of the three title isomers are quantitatively analyzed in situ with an accuracy of 5% for the molar fractions.Chiral surfaces are of growing interest for enantioselective adsorption and reactions. While metal surfaces can be prepared with a wide range of chiral surface orientations, chiral oxide surface preparation is more challenging. We demonstrate the chirality of a metal surface can be used to direct the homochiral growth of a thin film chiral oxide. Specifically, we study the chiral "29" copper oxide, formed by oxidizing a Cu(111) single crystal at 650 K. Surface structure spread single crystals, which expose a continuous distribution of surface orientations as a function of position on the crystal, enable us to systematically investigate the mechanism of chirality transfer between the metal and the surface oxide with high-resolution scanning tunneling microscopy. https://www.selleckchem.com/products/U0126.html We discover that the local underlying metal facet directs the orientation and chirality of the oxide overlayer. Importantly, single homochiral domains of the "29" oxide were found in areas where the Cu step edges that templated growth were ≤20 nm apart. We use this information to select a Cu(239 241 246) oriented single crystal and demonstrate that a "29" oxide surface can be grown in homochiral domains by templating from the subtle chirality of the underlying metal crystal. This work demonstrates how a small degree of chirality induced by slight misorientation of a metal surface (∼1 sites/20 nm2) can be amplified by oxidation to yield a homochiral oxide with a regular array of chiral oxide pores (∼75 sites/20 nm2). This offers a general approach for making chiral oxide surfaces via oxidation of an appropriately "miscut" metal surface.Compressible and ultralight all-carbon materials are promising candidates for piezoresistive pressure sensors. Although several fabrication methods have been developed, the required elasticity and fatigue resistance of all-carbon materials are yet to be satisfied as a result of energy loss and structure-derived fatigue failure. Herein, we present a two-stage solvothermal freeze-casting approach to fabricate all-carbon aerogel [modified graphene aerogel (MGA)] with a multi-arched structure, which is enabled by the in-depth solvothermal reduction of graphene oxide and unidirectional ice-crystal growth. MGA exhibits supercompressibility and superelasticity, which can resist an extreme compressive strain of 99% and maintain 93.4% height retention after 100 000 cycles at the strain of 80%. Rebound experiments reveal that MGA can rebound the ball (367 times heavier than the aerogel) in 0.02 s with a very fast recovery speed (∼615 mm s-1). Even if the mass ratio between the ball and aerogel is increased to 1306, the ball can be rebound in a relatively short time (0.04 s) with a fast recovery speed (∼535 mm s-1). As a result of its excellent mechanical robustness and electrical conductivity, MGA presents a stable stress-current response (10 000 cycles), tunable linear sensitivity (9.13-7.29 kPa-1), and low power consumption (4 mW). The MGA-based wearable pressure sensor can monitor human physiological signals, such as pulses, sound vibrations, and muscular movements, demonstrating its potential practicability as a wearable device.A range of methyl 2-fluorocyanoester derivatives were synthesized from dimethyl 2-fluoromalonate ester, and their efficacy as additives in lithium-ion battery (LIB) electrolytes was determined. The role played by the 2-fluorocyanoester additives on battery performance was explored by linear sweep cyclic voltammetry, NMR, GCMS, and XPS techniques. For all fluorocyanoester additives studied, initial reduction of the carbonyl group occurs which is then followed by formation of the corresponding radical anion. Possible degradation routes arising from loss of fluoride ion, loss of methyl radicals, and cleavage of the αβ carbon-carbon bond were observed, and all affect battery performance. Electrode protection upon addition of fluorocyanoesters to the electrolyte is the main contribution to the improvement of battery stability, but improvements on the electrode protection are somewhat offset by free radical processes initiated at the anode. Longer alkyl-chain fluorocyanoesters showed the best LIB improvement with effective cathode protection.Thermoacoustic (TA) effect has been discovered for more than 130 years. However, limited by the material characteristics, the performance of a TA sound source could not be compared with magnetoelectric and piezoelectric loudspeakers. Recently, graphene, a two-dimensional material with the lowest heat capacity per unit area, was discovered to have a good TA performance. Compared with a traditional sound source, graphene TA sound sources (GTASSs) have many advantages, such as small volume, no diaphragm vibration, wide frequency range, high transparency, good flexibility, and high sound pressure level (SPL). Therefore, graphene has a great potential as a next-generation sound source. Photoacoustic (PA) imaging can also be applied to the diagnosis and treatment of diseases using the photothermo-acoustic (PTA) effect. Therefore, in this review, we will introduce the history of TA devices. Then, the theory and simulation model of TA will be analyzed in detail. After that, we will talk about the graphene synthesis method. To improve the performance of GTASSs, many strategies such as lowering the thickness and using porous or suspended structures will be introduced. With a good PTA effect and large specific area, graphene PA imaging and drug delivery is a promising prospect in cancer treatment. Finally, the challenges and prospects of GTASSs will be discussed.