Optical property modulation induced by ionizing radiation is a promising approach for ultra-fast, lower time jitter detection of photon arrival time. If successful, this method can be utilized in time-of-flight positron emission tomography to achieve a coincidence time resolution approaching 10 ps. In this work, the optical property modulation based method is further developed with focus on a detection setup based on two crossed polarizers. Previous work demonstrated that such an optical setup could be utilized in radiation detection, though its detection sensitivity needed improvement. This work investigates the angle between polarizers and electric field distribution within the detection crystal to understand and improve the detection sensitivity of an optical polarization modulation based method. For this work, cadmium telluride (CdTe) was studied as the detector crystal . The 'magic' angle (i.e. optimal working angle) of the two crossed polarizers based optical setup with CdTe were explored theoretically and experimentally. The experimental results show that the detection sensitivity could be improved by around 10% by determining the appropriate 'magic' angle. We then studied the dependence of detection sensitivity on electric field distribution as well as on the bias voltage across the detector crystal using CdTe crystals. The experimental results show that a smaller electrode on the detector crystal, or a more concentrated electric field distribution could improve detection sensitivity. For CdTe, a detector crystal sample with 2.5 mm × 2.5 mm square electrode has twice the detection sensitivity of a detector crystal with 5 mm × 5 mm square electrode. Increasing the bias voltage before saturation for CdTe could further enhance the modulation strength and thus, the sensitivity. Our investigations demonstrated that by determining the proper working angle of polarizers and bias electrical distribution to the detector, we could improve the sensitivity of the proposed optical setup.We report growth, electronic structure and superconductivity of ultrathin epitaxial CoSi2 films on Si(111). At low coverages, preferred islands with 2, 5 and 6 monolayers height develop, which agrees well with the surface energy calculation. We observe clear quantum well states as a result of electronic confinement and their dispersion agrees well with density functional theory calculations, indicating weak correlation effect despite strong contributions from Co 3d electrons. Ex-situ transport measurements show that superconductivity persists down to at least 10 monolayers, with reduced Tc but largely enhanced upper critical field. Our study opens up the opportunity to study the interplay between quantum confinement, interfacial symmetry breaking and superconductivity in an epitaxial silicide film, which is technologically relevant in microelectronics.This work presents a H2S selective resistive gas sensor design based on a chemical field effect transistor (ChemFET) with open gate formed by hundreds of high temperature chemical vapour deposition (CVD) grown zinc oxide nanowires (ZnO NW). The sensing ability of pristine ZnO NWs and surface functionalized ZnO NWs for H2S is analysed systematically. ZnO NWs are functionalized by deposition of discontinuous gold (Au) nanoparticle films of different thicknesses of catalyst layer ranging from 1 to 10 nm and are compared in their gas sensing properties. All experiments were performed in a temperature stabilized small volume compartment with adjustable gas mixture at room temperature. The results allow for a well-founded understanding of signal-to-noise ratio, enhanced response, and improved limit of detection due to the Au functionalisation. Comprehension and controlled application of the beneficial effects of Au catalyst on ZnO NWs allow for the detection of very low H2S concentrations down to 10 ppb, and a theoretically estimated 500 ppt in synthetic air at room temperature.We studied the applicability of Heusler alloys Mn2RuZ (Z = Al, Ga, Ge, Si) to the electrode materials of MgO-based magnetic tunnel junctions. All these alloys possess Hg2CuTi-type inverse Heusler alloy structure and ferrimagnetic ground state. Our study reveals the half-metallic electronic structure with highly spin-polarized Δ1band, which is robust against atomic disorder. Next we studied the electronic structure of Mn2RuAl/MgO and Mn2RuGe/MgO heterojunctions. We found that the MnAl- or MnGe-terminated interface is energetically more favorable compared to the MnRu-terminated interface. Interfacial states appear at the Fermi level in the minority-spin gap for the Mn2RuGe/MgO junction. We discuss the origin of these interfacial states in terms of local environment around each constituent atom. On the other hand, in the Mn2RuAl/MgO junction, high spin polarization of bulk Mn2RuAl is preserved independent of its termination.Ruddlesden-Popper (RP) perovskites have attracted a lot of attention as the active layer for optoelectronic devices due to their excellent photophysical properties and environmental stability. Especially, local structural properties of RP perovskites have shown to play important roles in determining the performance of optoelectronic devices. Here, we report the photodetector performance variation depending on the crystallinity of n = 4 two-dimensional (2D) RP perovskite polycrystalline films. Through controlling the solvent evaporation rate, 2D RP perovskite films could be tuned between highly- and randomly-orientated phases. We investigated how different factors related to the film crystallinity are reflected in the variation of photodetector performances by considering grain boundary and low energy edge state effects in n = 4 RP perovskites. Better understanding the interplay between these factors that govern the photophysical properties of the devices would be beneficial for designing high-performance RP perovskite-based optoelectronic devices. Four-dimensional (4D) digital subtraction angiography (DSA) offers a method for evaluating hemodynamics. It is, however, unclear how the delivered contrast medium interacts with the physiological blood flow, and how hemodynamic information may be inferred from the mixture of the contrast medium and blood. In this study, we present a theoretical explanation of contrast dynamics, and an accompanying algorithm for estimating blood flow velocity. We retrospectively recruited 23 patients who underwent both 4D DSA and magnetic resonance (MR) phase-contrast imaging. The 4D DSA-reconstructed contrast dynamics were first studied for the internal carotid arteries. https://www.selleckchem.com/products/Beta-Sitosterol.html Using physical laws governing fluid motion within a curved tube, we showed that the reconstructed contrast dynamics obeyed a simple advection equation. We then proposed an algorithm for estimating the contrast dynamics using angiographic data, and subsequently estimated the axial blood flow velocity using an advection equation. The estimated velocities were compared using three techniques the Fourier technique, Lin's method, and MR phase contrast.